■
3-76
3.9.2 Measurement
Make settings related to measurement on this screen. Select the Measurement
tab.
a) Optical Measurement Mode - Selection
Select measurements to be performed in optical mode. Touch the “Selection”
button (1) to open the measurement mode setup screen (Fig. 2).
(Fig. 1) (Fig. 2)
3 patterns can be prepared. Measurement modes selected here will be effective
when specified in Measure Selection (2) on the Setup screen (Fig. 3).
(Fig. 3)
b) Starting Condition
Set the measurement mode when power is turned on and when the measurement
mode is switched.
(Fig. 1)
Favorite Settings : The system starts
with measurement
contents selected
on the mode
selection screen.
Latest Settings : The system starts
with measurement
contents active
when power was
turned off last time.
(1)
(2)
To Next Page
Loading...
