Tomey OA-2000 - Browsing and Editing Axial Length Measurement

3-19 ■
3.3.4 Browsing and editing axial length measurement
Touch the "View" button (1) at the lower left of the measurement screen (Fig. 1) to
open the axial length view screen (Fig. 2).
Touch the “Measure" button (2) on the view screen (Fig. 2) to return to the
measurement screen (Fig. 1).
(Fig. 1) (Fig. 2)
a) Browsing measurement values
(Fig. 1)
1) Measurement values (1) and scanned image / waveform (2) are displayed
with the average data selected when the screen appears. Touch the data
selection buttons (3) to move the cursor (4).
The following marks are assigned to the measurement data.
2) Touch the display area selection button (5) to show the image at
magnification and position where the selected section can be checked.
Axial / ACD, Lens / Corneal thickness / All
＊
: Data used for calculating IOL power
! : Data with low reliability
C : Callipered data
(2)
(1)
(5)
(4)
(3)
(1)
(2)