Tomey OA-2000 - Turning the Power on and Adjustment after Turning the Power on

3-7 ■
(Fig. 1) (Fig. 2)
[Resuming communication from the no communication state]
1) Click the “New” button (1) to clear the existing data.
2) Select the same measurement mode as that of the AL-4000 using the
“Setup” button (2).
3) Click the “AL-4000 communication check” button (3) to resume communication.
(Fig. 3)
3.2.3 Turning the power on and adjustment after turning the power on
a) Turning the power on
■ To restart the system, turn the power off, wait for ten seconds or so, and
turn it on again.
1) Turn on the power switch (1) on the side of the main unit.
2) The startup screen (Fig. 2) appears and then displays the optical
measurement screen.
(2)
(1)
(1)
(2)
(3)
(1)
(Fig. 1)
(Fig. 2)