■
3-58
3.8 Export, print, and save
Set desired functions to 2 buttons for export, print, and save provided on the
operation screen before executing the export, print, and save functions. (Refer to
“3.9.4 a) Setting functions of save, export, and print buttons.”)
The print and export buttons work according to the preset functions when touched
after measurement.
(Fig. 1)
Export
Print
Save
Export&Save
Export&Print
Print&Save
ALL (export, print, and save)
3.8.1 Export
■ The network support system “TOMEY Link” (optional) or the inspection
data receiving software “DATA Transfer” (included in the package) is
required for data communication.
■ Refer to the corresponding operation manual for the TOMEY Link and
DATA Transfer settings.
■ Connection setting is required for connecting with TOMEY Link and
DATA Transfer. Refer to "3.9.4 d) PC connection settings" to make
settings.
■ Data cannot be sent in some configurations if the ID number is not
entered. Refer to “3.9.1 General.”
■ It is recommended to send data after entering the ID number.
The data can be sent without ID numbers entered; however, the
corresponding patient may not be traced from the inspection file output
from DATA Transfer. When the data was sent without entering the ID
number, check the content of the inspection file immediately after
sending the data, and move and save the file in an appropriate location. In
addition, when data was sent to TOMEY Link, all the data without ID
number are regarded as the data of the same patient so that they must be
handled with great care to avoid mishandling.
■ Waveforms of the same form as those to be printed out are output.Refer
to “3.8.2 Printing” for details.
Button 1
Button 2
To Next Page
Loading...
