■
3-28
3.3.7 Browsing and editing pupil diameter and corneal diameter measurement values
(Fig. 1)
1) Touch the "DIA" button (1) on each view screen to open the pupil/corneal
diameter view screen (Fig. 2).
(Fig. 2)
2) Measured pupil diameter (2) and corneal diameter (3) are shown. The fitting
circle and center point for analyzing the pupil diameter, and measurement
lines for analyzing the corneal diameter are shown on the CCD image.
3) Touch any of the Center Point buttons (4). The circle (5) moves on the image,
and the X and Y values of the measurement (2) change accordingly. Touch
the circle (5) on the image to move the center point of the circle to the
touched point.
4) Touch the up/down arrow buttons for the diameter editing tool (6) to change
the diameter of the circle (5).
5) Touch the Left point and Right point arrow buttons of the corneal diameter
editing tool (7). The measurement lines (8) on the image move accordingly
and the corneal diameter value (3) changes.
6) Touch the “Initial Position” button (9) to reset each value to the status when
the pupil/corneal diameter view screen opened.
7) Touch the “Apply” button (10) to define the changes. Nothing can be returned
to the original positions after the “Apply” button is touched.
(1)
(4)
(3)
(2)
(7)
(10)
(4)
(6)
(8)
(8)
(9)
(9)
(5)
To Next Page
Loading...
