3-37
3.8.4 Data Receiving
Please refer to "3.9 Data Management with TOMEYLink (Elec-
tronic Medical Record Support System)" to send Data to
TOMEYLink.
1) Make sure before receiving data that there is no
data left in the Data Standby Screen. Then, change
the screen to the Data Communication Screen (Fig.
2). If any data is left remaining in the screen, de-
lete such data by long pressing F4 Key A.
2) Next press "W" or "X" of the Operating Panel
and align the cursor to "RECEIVE". Then press
F3 Key B to change the screen to the Data Re-
ceiving Screen (Fig. 3).
3) When F3 Key C is pressed, the screen will be
ready for receiving data. Then, operate the data
sending side to send data.
3.8 Sending and receiving data
(Fig. 1)
(Fig. 2)
(Fig. 3)
To Next Page
Loading...
Need help?
General
