Tomey SP-100 - Page 58

3-42
2) Press F2 key B to switch screen from DATA
SENDING (Fig.2) to DATA CONFIRMATION
(Fig.3).
Make sure Serial Communication Cable is prop-
erly connected to external device. Press F3 key
C to send data to TOMEYLink. When ID is
missing, whole data will not be sent.
Press F4 key D to go back to DATA COMMU-
NICATION (Fig.1).
3) "NOW COMMUNICATING" is displayed, while
data is sent (Fig.4). Press F4 key E to cancel
sending data.
4) When data is properly sent, SENTCOMPLETE!
is displayed (Fig.5). Press F3 key F to go back
to DATA SENDING screen (Fig.2).
(Fig. 2)
(Fig. 3)
(Fig. 4)
(Fig. 5)
3.9 Data Management with TOMEY Link