1-3䢢
䕔
Do not allow any person to place their hands or fingers in the clearance
under the head or the section immediately under the chin rest. Their
hands or fingers may be caught and injured.
Never insert fingers or objects through the capture window. Malfunction
or failure of the instrument or faulty analysis results may occur.
Do not lean on the instrument or press the instrument from the top. The
instrument may topple over, resulting in mechanical failure or injuries.
Be careful to not exceed the diagnosis time.
Always check that there is no problem with the instrument and patient to
ensure safety.
If any problem is found with the instrument or patient, take appropriate
action, such as stopping operation, to maintain patient safety.
Immediately stop capturing images if the patient shows any signs of
photosensitive epilepsy.
Faulty fixing of the sight, eyelid drooping, trichiasis, corneal diseases,
etc. may affect the analysis result or measurement of corneal thickness.
When the captured image is unclear, use another image for analysis or
capture another image. If the measurement result of the corneal
thickness is doubtful, review the inspection result by performing
measurement again or another inspection.
When using captured images or analysis results obtained with this
instrument for diagnosis, also refer to the results of other examinations.
Capturing conditions may affect the precision of images or analysis
result.
Do not use the “central corneal thickness” and “ultrasonic correction for
central corneal thickness” output from this instrument to directly correct
the eye refractive power. Other examination methods should also be
used in conjunction with the above.
Do not allow the patient to touch the instrument.
Peel off the top sheet of chin rest paper and clean the forehead pad with
a cloth or the like dampened with alcohol before capturing an image for
the next patient.
Precautions after operation
Do not place any container with liquid in it on the instrument. Any liquid
entering the instrument may cause electric shock or failure.
Do not use organic solvents such as thinner, benzene, or acetone to
clean the instrument. Fire or electric shock may occur. (These can also
corrode the resin or coating of the instrument cover.)
Hold the plug when disconnecting the power plug from the outlet to avoid
placing excessive force on the cord. Pulling the cord may damage the
inner core wires, resulting in electric shock or fire.
Disconnect the power plug from the outlet to ensure safety when the
instrument is not operated for long periods.