Configuring the Receiver
17
P/N: 1004636-01
Configuring the Receiver
The
ipaddress
is the receiver’s IP address;
port number
is the port number you should specify if set to a number
other than the default port number (port 80 for HTTP, and port 443 for HTTPS).
Once the information is entered, the main page displays.
Figure 8: Vanguard Web Interface – Main Page
3. Enter the login name and password to access the Web interface.
The default login and password are
admin
. Login names and passwords are case sensitive, and can be up
to 12 alphanumeric characters.
Figure 9: Vanguard Web Interface – Login
4. Click LOGIN.
After logging in to the Web interface, you can view and modify the receiver parameters.
When accessing the Web interface via SSL communications, a warning may appear stating the
security certificate was issued by a company you have not chosen to trust. You can safely ignore this
warning and continue with the login procedure. Your communications will use SSL.
You can access the receiver without entering the login name and password; however, you will be
restricted to view-only activities.
To Next Page
Loading...
Need help?
General
