43
10. CONNECTING TO EXTERNAL DEVICES
3. Set "Authentication" to "Yes" or "No".
If "Authentication" is set to "Yes" for the OS the
passkey will also need to be input on the
companion device.
4. When "Authentication" is set to "Yes", input the
same passkey as that for the intended companion
device. Even if "Authentication" is set to "No", a
passkey is requested when authentication is set
on the companion device being used.
• Up to 16 numeral characters can be input. Input
characters will be displayed as asterisks (e.g.
"*****"). The passkey was set to "0123" at the
factory.
5. Press [OK] to finish settings. Move on to the
Bluetooth communication.
"10.2 Communication between the OS and
Companion Device"
PROCEDURE Set Bluetooth communication mode to "Master"
• When setting communication mode to "Master", companion devices should be registered first. If
companion devices have already been registered, proceed to step 6.
1. Power on the companion device to be registered.
2. Select "Bluetooth" in "Comms mode".
"PROCEDURE Set Bluetooth
communication mode to "Slave"" Step1
3. Press [LIST] to display a list of all registered
devices (no devices are registered when the
instrument is shipped).
To Next Page
Loading...
Need help?
General
