142
21.WARNING AND ERROR MESSAGES
The following is a list of the error messages displayed by the instrument and the meaning of each
message. If the same error message is repeated or if any message not shown below appears, the
instrument has malfunctioned. Contact your local dealer.
Backup battery dead. Clock display may no longer be correct.
The voltage supplied by the lithium battery either declines or is completely discharged.
Ask your local dealer to replace the battery for you.
Bad condition
The air is shimmering a lot, etc., measuring conditions are poor.
The center of the target cannot be sighted.
Resight the target.
Unsuitable distance measurement conditions when reflectorless measurement is set. When
reflectorless measurement is set, distance cannot be measured because the laser beam is
striking at least two surfaces at the same time.
Choose a single surface target for distance measurement.
C Precautions for setting prism: "10. TARGET SIGHTING"
Calculation error
During resection measurement the same point is registered multiple times. Set another known
point so that the known point coordinates do not coincide.
Coordinates identical to the known point coordinates observed during resection exist.
During surface area calculation, conditions necessary for calculations are not met. Check
conditions and try again.
An error occurred during calculation.
Device list is full !!
No more Bluetooth devices can currently be registered.
Delete unnecessary devices from the list and try again.
Disconnect Bluetooth
Wireless connection disconnected. Re-connect and try again.
Error: Read Build Info.
Error: Read JOG Setting
Error: Read OS Parameter
Error: Read sysflg
Error: Self check
Error: Write sysflg
Press [OK] to cancel the message. If this error message appears frequently, contact your local
dealer.
Incorrect password.
Input password does not match set password.
Input correct password.
To Next Page
Loading...
Need help?
General
