75
13. DISTANCE MEASUREMENT
• During fine average measurement, the distance data is displayed as SD1, SD2,... to SD9. When the
designated number of measurements has been completed, the average value of the distance is
displayed in the "SDA" line.
• If the tracking measurement is conducted with the target type "N-Prism", the measured data for a
distance exceeding 250m is not displayed.
• The distance and angle that are most recently measured remain stored in the memory until the
power is off and can be displayed at any time by pressing [CALL].
C Allocating [CALL]: "20.6 Allocating Key Functions"
The following explains distance measurement and the features used to output measurement data to
a computer or external devices.
C"9. CONNECTING TO EXTERNAL DEVICES", Communication cables: "25. OPPTIONAL
ACCESSORIES". Output format and command operations: "Communication manual"
PROCEDURE
1. Connect instrument and external device.
2. Sight the target point.
3. Press [HVDOUT-T] or [HVDOUT-S] to measure
the distance and output the data to the external
device.
4. Press [STOP] to stop outputting data and return
to Obs Mode.
13.4 Distance Measurement and Outputting the Data
To Next Page
Loading...
Need help?
General
