39
8. POWER ON/OFF
PROCEDURE Power OFF
1. Press and hold (about 1sec) the power key on the
side of the instrument.
G
• When there is almost no battery power
remaining, the battery icon in the status bar will
start to blink.In this event, stop measurement,
switch off the power and charge the battery or
replace with a fully charged battery.
• To save power, power to the instrument is
automatically cut off if it is not operated for a
fixed period of time. This time period can be set
in "Power off" in <Inst.config.>.
C"20.2 Instrument Configuration"
When using for the first time, or after performing a cold
boot, the screen for configuring the touch panel will be
displayed.
Follow the instructions on the screen. Tap the cross-
hairs at the center of the display with the stylus pen.
Tap 5 times. Press {ENT} to complete touch panel
configuration. Press {ESC} to retain previous settings.
$
• Touch panel configuration can be performed at any
time during normal operation by pressing [PNL
CAL] in <Inst.config.>.
C"20.2 Instrument Configuration"
8.1 Configuring the Touch Panel
To Next Page
Loading...
Need help?
General
