15. RESECTION MEASUREMENT
86
4. Sight the first known point and press [MEAS] to
begin measurement.
The measurement results are displayed on the
screen.
• When [ANGLE] has been selected, the distance
cannot be displayed.
5. Press [YES] to use the measurement results of
the first known point.
• You can also input target height here.
•Press [NO] to return to the screen in step 4 and
perform measurement again.
6. Repeat procedures 4 to 5 in the same way from
subsequent points.
When the minimum quantity of observation data
required for the calculation is present, [CALC] is
displayed.
[AUTO] will be displayed for the 3rd point onwards
for Auto Tracking models. Pressing [AUTO] will
rotate the instrument to the next point and start
auto measurement.
• Press [STOP] during auto measurement to
display a confirmation message. Press [YES] in
this message to return to the first point measured
using auto measurement. Measurement can
now be continued manually. Press [NO] to
continue measurement manually from the
current position.
To Next Page
Loading...
