Topwisdom TL-A1 - Page 59

泰智科技
Shenzhen Topwisdom Technology Co., Ltd
53
feeding roller, active at low
OUT8 = Wind/SPI
Wind/SPI Blowing signal or spindle signal, the signal is
multiplex, used for the blowing signal in case of a normal model;
used as start and stop signal for the spindle motor in case of rotary
cutting model, active at low level
OUT9 = X-PUL
X-PUL- X axis step pulse, connect to the PUL- of step motor
driver
OUT10 = X-DIR
X-DIR- X axis direction signal, connect to the DIR- of step motor
driver
OUT11 = Y-PUL
Y-PUL- Y axis step pulse, connect to the PUL- of step motor
driver
OUT12 = Y-DIR
Y-DIR- Y axis direction signal, connect to the DIR- of step motor
driver
OUT13 = Z/U-PUL
Z/U-PUL- Z/U axis step pulse, connect to the PUL- of step
motor driver
OUT14 = Z/U-DIR
Z/U-DIR- Z/U axis direction signal, connect to the DIR- of step
motor driver
OUT15= LPWM
LPWM Be used to control the LASER power signal
OUT16 = L-ON
L-ON Laser enable control