Shenzhen Topwisdom Technology Co., Ltd
62
4.5 Tool Switch
In the standby interface, press the "Enter" key, and select "Knife/Knife” to enter the control
interface; select the rotary cutting head or laser. When the rotary cutting head is selected, the
Control Card adopts cutting with the rotary cutting head. When working, turn on the spindle
first, then after a delay, wait for cutting head of the spindle to run the rated speed, then
precede cutting, and when in idle motion, lift it to the specified height. After completion,
return to the specified stop position, then close the spindle and wait for the spindle to
completely stop before exiting the machining. When laser is selected, cutting proceeds with
the laser head. The spindle is not activated during operation, and no descending / ascending of
the cutting head.
4.6 Processing Flow
1. When rotary cutting is required, select the rotary cutting head.
2. Place the material to be cut, then press the "Enter" key, and select "Knife/Knife/Nip Rolls”
to open the roller to press. (If there is a press device.)
3. Perform the head presetting; in the standby interface, press ESC, open Z+/- movement
interface, and press up/down key to move the cutting head to the cutting position of the
material. Press the "Pulse" key to record the head presetting position.
4. If there is any head presetting block, perform the automatic presetting with reference to
Section 4.3.2.
5. Press up/down key to move the cutting heads to the stop position when completion
(Standby), press the "Range" key to record the stop position.
6. Press the "Origin" to test if the tool position is normal.
7. Back to standby interface, Move the X, Y axis, move the cutting heads to the Set Point,
and press the Origin key.
8. Press Start to begin cutting. When processing, first open the spindle, wait for the spindle
to run to the rated speed, lower the cutting tool, and when it is idle, lift it to the specified
height. After completion, return to the specified position, then close the spindle and exit
the processing.
9. If you want to switch to the laser cutting, press the "Enter" key, and select
"Knife/Knife/Cutting Tool", then change it to Laser. At this time, move the laser head to
To Next Page
Loading...
