Toro 34215 - Adjusting the Spreader Pattern

AdjustingtheSpreaderPattern
Ifthespreaderiscastingmaterialinaunequalside-to
side—toolight/heavytooneside—(seeFigure30andFigure
31),adjustthespreader-patterncontrolasfollows:
Figure30
1.Heavytoleftside
3.Heavytorightside
2.Moveramppatternto
shadedposition
Note:Donotadjusttherampsthatsplittheproductow.
Adjustonlythefrontorrearramppositions.
1.Unlockthespreader-patterncontrolbyturningthe
handlecounterclockwise90degreesasshownin2of
Figure31.
Figure31
1.Spreader-patterncontrol4.Startnotchifpatternis
heavytorightside
2.Rotatecounterclockwise
tounlock
5.Rotateclockwisetolock
3.Startnotchifpatternis
heavytoleftside
2.Adjustthespreaderpatternasfollows:
•Ifthematerialisbroadcasttooheavyattheleftside
ofthemachine,pullthespreader-patterncontrol
upslightly;referto3ofFigure31.
•Ifthematerialisbroadcasttooheavyattheright
sideofthemachine,pushthespreader-pattern
controldownslightly;referto4ofFigure31.
3.Lockthespreader-patterncontrolbyturningthe
handleclockwise90degrees;referto5ofFigure31.
UsingtheDeectorGate
Usethedeector-gatecontroltotemporarilystopordeect
granularmaterialawayfromsidewalks,parkinglots,patios,or
anywherethegranularchemicalsarenotdesired.
Note:Thedeectorgatechangesthedischargedofmaterials
fromtheleftsideofthespreaderonly.
Pushtheknobforthedeector-gatecontroldowntolower
thedeectorandtemporarilydeectthegranularmaterial.
Pulltheknobuptoraisethedeectorfornormalcastingof
materialsattheleftsideofthemachine.
Figure32
1.Fence
3.Deectorgatelowered
2.Flowers
31