Toro 34215 - Controls System Maintenance; Adjusting the Pattern Control Cable for the Spreader

ControlsSystem
Maintenance
AdjustingthePatternControl
CablefortheSpreader
1.Shutofftheengine,settheparkingbrake,removethe
key,andwaitforallmovingpartstostopbeforeleaving
theoperatingposition.
2.Emptythehopper;refertoEmptyingtheHopper
(page28)
3.Closetheimpellergatebypushingthewide-distribution
impeller-gateleverforwardfully(Figure82).
Figure82
1.Unlock—spreadpattern
controlhandle(rotate
counterclockwise)
3.Lock—spreadpattern
controlhandle(rotate
clockwise)
2.Pushdown—spread
patterncontrolhandle
4.Push
forward—wide-distribution
impeller-gatelever
4.Rotatethespread-pattern-controlhandle
counterclockwise,pushthehandledown,androtate
thespread-pattern-controlhandleclockwise(3)refer
toFigure82.
5.Loosenthejamnutattheendofthepattern-control
cable(Figure83).
Figure83
1.Jamnut(patterncontrolcable)
2.Linkagerod
3.Impellershaft
4.1/8inch(3.2mm)gapbetweenramptoothandimpeller
shaft
5.Ramptooth
6.Pullthelinkageroduntilthereis1/8inch(3.2mm)
gapbetweentheramptoothandtheimpellershaft
(Figure83).
7.Tightenthejamnut(Figure83).
8.Adjustthespread-pattern-controlhandle;referto
AdjustingtheSpreaderPattern(page31).
62