Toro 34215 - Servicing the Fuel Strainer

Figure67
1.Fueltank5.Tanksupports
2.Strainer
6.Bolt6x25mm
3.Fuelhose
7.Clamps
4.Nuts8mm
6.Loosenthehoseclampanddisconnectfuelhosefrom
thettingonthecarburetor(Figure68).
Figure68
1.Fitting(carburetor)
3.Fuelhose
2.Clamp
7.Removethefueltankfromthecrankcaseoftheengine
(Figure67andFigure69).
Figure69
1.Fuelhose
3.Strainer
2.Boss4.Fueltank
CleaningtheFuelStrainer
1.Loosenthehoseclampanddisconnectthefuelhose
fromthettingatthefuelstrainer(Figure67).
2.Rotatethefuelstrainercounterclockwiseandremoveit
fromthefueltank(Figure67).
Note:Checkthesealandthefuelstrainerfordamage
orwear.Replacethesealorfuelstrainerifthesealor
straineraredamaged.
3.Cleanthefuelstrainerinfreshgasolineorkerosene.
4.Threadthefuelstrainerintothefueltank(Figure67).
5.Torquethefuelstrainerto3.0to4.0N∙m(2.2to2.9
ft-lb).
6.Alignthefuelhosethatyouremovedinstep1overthe
ttingonthefuelstrainer(Figure67andFigure69).
7.Securethehosetothestrainerttingwiththeclamp
(Figure67andFigure69).
InstallingtheFuelTank
1.Applymedium-gradethread-lockingcompoundtothe
8mmstudsinthefueltankandthe2bolts6x25mm.
2.Alignthefueltanktothetanksupportsontheengine
(Figure67).
3.Alignthefuelhosethatyouremovedinstep6of
RemovingtheFuelTank(page53)tothettingonthe
carburetor(Figure68andFigure69).
4.Securethehosetothecarburetorttingwiththeclamp
(Figure68).
5.Assemblethetanktothetanksupportsontheengine
withthe2bolts6x25mmand2nuts8mm(Figure
67).
6.Torquethe6mmboltsto945to1171N∙m(86to106
in-lb).
7.Handtightenthesedimentcupintothecarburetor.
54