Toro 41177 Multi-Pro 1250 - Lubrication; Greasing the Sprayer

Figure 34
1. Front jacking points
T he jac king point at the rear of the spra yer is on
the rear frame suppor t, betw een the angle w elds
( Figure 35 ).
Figure 35
1. Rear jacking points
Lubrication
Greasing the Sprayer
Lubricate all bearings and bushings after ev er y
100 hours or once a year , whic hev er occurs first.
Grease T ype: No . 2 General Pur pose Lithium
Base Grease
1. Wipe the g rease fitting clean so that foreign
matter cannot be forced into the bearing or
bushing .
2. Pump g rease into the bearing or bushing .
3. Wipe off ex cess g rease .
T he g rease fittings positions are illustrated b y
the follo wing: Figure 36 through Figure 42 .
Figure 36
At the wheels, three on each side
1. Grease point
Figure 37
Steering rods
1. Grease point
42