18
Factory Reset
Select this function to reset the controller to the factory default parameters. Schedule B, C and Auxiliary will be disabled and all
FACTORY RESET
RESET TO FACTORY
DEFAULTS? YES
and all of their parameters will be cleared or set to OFF. Schedule A will be set with a WEEKDAY schedule with all 7 days active.
It will have one start time set to OFF and all zone runtimes set to OFF.
Help/Setup
Alerts
The EVOLUTION
®
controller always checks the system for proper function and it will provide feedback if it detects any system abnormality. The Alerts menu
allows you to view and clear detected system faults.
Alert Listings
Freeze Hold - EVOLUTION
®
detectedtemperaturesbelowthesetFREEZEOFFtemperaturewhenthecontrollertriedtoirrigate.(OnlyavailableifRain/Freeze
orWeathersensorisconnected).
Short - EVOLUTION
®
detected a short in the zone.
Overcurrent - EVOLUTION
®
detected an over current in the zone. Over current occurs when a terminal or combinations of terminals exceeded the
recommended current draw rating.
Low Battery - EVOLUTION
®
detected no battery installed or the battery’s power is low. Once the Low Battery alert is cleared, it will not display again unless a
Factory Reset is performed or the newly installed battery runs low again.
Low A/C Power - EVOLUTION
®
detected low or no A/C power.
Factory Reset - EVOLUTION
®
encountered an error that required the system to reset to the factory defaults.
Communication Error - EVOLUTION
®
encountered a communication error with the output zones.
Clearing an Alert
You can clear Alerts using the CLEAR ALL command to erase them all, or you can clear each alert separately.
Step 1 – Press HELP/SETUP.
Step 2 – Use the Up or Down arrows to select the Alerts. Press SELECT .
ALERTS
CLEAR ALL
LOW BATTERY
Step 3 – Use the Up or Down arrows to select individual alerts or CLEAR ALL. Press SELECT .
Step 4 – Use the Up or Down arrowstoconrm(Yes)orcancel(No).PressSELECT .
To Next Page
Loading...
Need help?
General
