Toro ProCore 648s - Setting the Hole Depth; Setting the Hole Spacing

g357974
Figure54
4.PressthecenterbuttontoselecttheSetSpacing
option.
Note:TheSetSpacingscreendisplays.
5.Adjusttheholespacing(Figure55)asfollows:
•PresstheInfoCentercenterbuttonto
decreaseholespacing.
•Presstherightbuttontoincreasehole
spacing.
g357977
Figure55
6.PresstheleftInfoCenterbuttontosaveyour
settingandexittheSetHoleSpacingscreen.
7.RotatetheignitionkeytotheOFFposition.
SettingTineDiameter
1.Ensurethatthecoringheadisraised;referto
RaisingtheCoringHead(page27).
2.RotatetheignitionkeytotheRUNposition.
g358601
Figure56
3.PresstherightInfoCenterbuttonuntiltheSetting
theTineDiameterscreendisplays(Figure57).
g372377
Figure57
4.PressthecenterbuttontoselecttheSet
Diameteroption.
Note:TheSetDiameterscreendisplays.
5.Adjustthetinediameter(Figure58)asfollows:
•PresstheInfoCentercenterbuttonto
decreasetinediameter.
•Presstherightbuttontoincreasetine
diameter.
34