Toro ProCore 648s - Checking the Hydraulic Lines; Hydraulic Fluid Specifications

ofconventionaluid.Theoilisavailablein19L
(5USgallon)pailsor208L(55USgallon)drums
fromyourauthorizedthemanufacturerdistributor.
Checkingthe
Hydraulic-FluidLevel
ServiceInterval:Beforeeachuseordaily
Important:Checkthelevelofthehydraulic
uidbeforetheengineisrststartedanddaily
thereafter
Thehydraulicreservoirislledatthefactorywith
high-qualityhydraulicuid.
1.Preparethemachineformaintenancereferto
PreparingtheMachineforMaintenance(page
65).
2.Removethebeltcover;refertoRemovingthe
BeltCover(page66).
3.Cleantheareaaroundthellerneckandthe
capofthehydraulictank(Figure178).Remove
thecapfromthellerneck.
g340187
Figure178
1.Dipstick
2.Cap
3.Hydraulictank
4.Removethedipstickfromthellerneckand
wipeitwithacleanrag.Insertthedipstickinto
thellerneck;thenremoveitandcheckthe
leveloftheuid.Theuidlevelshouldbeupto
themarkonthedipstick(Figure179).
g340188
Figure179
1.Dipstick2.Fullmark
5.Ifthelevelislow,addthespeciedhydraulic
uidtoraisetheleveltothefullmark.
6.Installthedipstickandcapontothellerneck.
7.Installthebeltcover;refertoInstallingtheBelt
Cover(page67).
ChangingtheHydraulic
FluidandFilters
ServiceInterval:Every400hours
Every200hours
Hydraulicreservoircapacity:approximately6.6L
(1.75USgallons)
Important:Donotsubstituteautomotiveoillters
orseverehydraulicsystemdamagemayresult.
Note:Removingthereturnlterdrainstheentire
uidreservoir.
1.Preparethemachineformaintenancereferto
PreparingtheMachineforMaintenance(page
65).
2.Placeadrainpanunderthelters,removethe
oldlters,andwipethelteradaptergasket
surfaceclean(Figure180).
82