Toro PROLINE 44409 - Control Handle Replacement

ThrottleControlRemoval(continued)
4.Removethethrottlecablefromthethrottleleverontheengine.
5.Cuttheziptiessecuringthethrottlecabletothechokecable.
6.Removethe2boltsandnutssecuringthethrottlecontroltothecontroltower.
7.Pullthethrottlearmthroughtheopeninginthecontroltowerandremove
fromthemachine.
ThrottleControlInstallation
1.Placethethrottlearmintotheopeninginthecontroltower.
2.Installthe2boltsandnutssecuringthethrottlecontroltothecontroltower.
Torqueboltsandnutsto13N•m(160±20in-lb).
3.Installziptiessecuringthethrottlecabletothechokecable.
4.Installthethrottlecabletothethrottleleverontheengine.
5.Tightentheboltsecuringthethrottlecabletotheenginechokemountcable
outerhousing.
g311104
Figure78
6.Connectthepositivebatterycablerst,thenthenegativebatterycableto
thebattery.
ControlHandleReplacement
ControlHandleRemoval
1.Parkthemachineonalevelsurfaceandsettheparkingbrake.Stopthe
engine,waitforallmovingpartstostopandremovethekey.
2.Disconnectthebatterybyremovingthenegativebatterycablerst,then
thepositivecablefromthebattery.
3.Disconnectthewireharnessfromtheoperator’spresenceswitchonthe
motioncontrolarm.
Controls:ServiceandRepairs
Page6–16
PROLINE®ServiceManual
3431-988RevA