Starter Solenoid Removal (continued)
g420413
Figure 125
Starter Solenoid Installation
1. Install the starter solenoid. Using a T30 torx driver , install the 2 (1/4 inch)
bolts to secure the starter solenoid to the chassis.
g420413
Figure 126
2. Using a 3/8 inch socket, install the 2 (#10) nuts to connect the 2 wire harness
connectors to the starter solenoid.
2000 Series Z MASTER®Service Manual Page 8–7 Electrical: Service and Repairs
3460-328 Rev A
To Next Page
Loading...
