Light Switch T esting
g427667
Figure 141
The light switch is a Single Pole Single Throw switch that supplies battery voltage
to the front light and any added accessory light. When switched on, the circuit
closes, and there is continuity between the terminals.
• Light switch on (“I”) the switch will have continuity .
• Light switch of f (“O”) the switch will NOT have continuity .
Ignition Switch Replacement
Ignition Switch Removal
1. Park the machine on a level surface and disengage the PT O. Stop the
engine, wait for all moving parts to stop and remove the key . Engage the
parking brake.
2. Disconnect the battery by removing the negative cable rst, then the positive
cable from the battery .
3. Remove the control panel. Refer to Control Panel Removal ( page 8– 9 ) .
4. Compress the 2 tabs on the side of the switch and remove the ignition switch.
Ignition Switch Installation
1. Insert the light switch into the control panel.
2. Install the control panel. Refer to Control Panel Installation ( page 8– 12 ) .
3. Connect the battery by installing the positive cable rst, then the negative
cable to the battery .
2000 Series Z MASTER®Service Manual Page 8–17 Electrical: Service and Repairs
3460-328 Rev A
To Next Page
Loading...
