Toro Z MASTER 2000 Series - Flush Front Light Replacement

Parking Brake Switch Installation (continued)
4. Connect the battery by installing the positive cable rst, then the negative
cable to the battery .
Parking Brake Switch T esting
g427668
Figure 149
The parking brake switch is a single pole plunger type switch (normally open)
with two terminals. When the plunger is depressed (parking brake ON), the
circuit closes and there is continuity between the terminals. This allows battery
voltage to ow to the Smart Hour Meter for the safety interlock system.
• Parking brake ON, the switch should have continuity (closed).
• Parking brake OFF , the switch should NOT have continuity (open).
Flush Front Light Replacement
Flush Front Light Removal
1. Park the machine on a level surface and disengage the PT O. Stop the
engine, wait for all moving parts to stop and remove the key . Engage the
parking brake.
2. Disconnect the battery by removing the negative cable rst, then the positive
cable from the battery .
3. Using a T30 torx driver , remove the 2 (1/4 inch) bolts securing the front
bumper to the chassis.
2000 Series Z MASTER®Service Manual Page 8–23 Electrical: Service and Repairs
3460-328 Rev A