Seat Installation (continued)
g421557
Figure 78
3. Lift the seat forward and connect the wire harness to the seat pressure
switch. T ilt the seat back into position.
4. Using a 1/2 inch socket, install the 2 (5/16 inch) nuts and carriage bolts to
secure the rear of the seat to the chassis.
5. Connect the battery by installing the positive cable rst, then the negative
cable to the battery .
MYRIDE ® Replacement
MYRIDE ® Removal
1. Park the machine on a level surface and disengage the PT O. Stop the
engine, wait for all moving parts to stop and remove the key . Engage the
parking brake.
2. Disconnect the battery by removing the negative cable rst, then the positive
cable from the battery .
3. Move the MYRIDE® springs to the #5 position.
4. Move the seat as needed and, using a 1/2 inch socket, remove the 4 (5/16
inch) lock nuts and carriage bolts securing the seat pan to the MYRIDE®
platform.
5. With assistance, remove the seat and pan assembly .
6. Using a 3/4 inch socket, remove the 2 (1/2 inch) lock nuts securing the lower
mounts of the rear shocks to the ROPS.
2000 Series Z MASTER®Service Manual Page 6–17 Chassis: Service and Repairs
3460-328 Rev A
To Next Page
Loading...
