Toro Z MASTER 2000 Series - Right Hand Pod Replacement

Left Hand Pod Installation (continued)
g421543
Figure 86
3. Using a T30 torx driver , install the 3 (1/4 inch) shoulder bolts securing the
LH pod to the chassis.
g432460
Figure 87
4. Install the 2 retaining clips to secure the fuel ller neck to the LH steering
pod assembly .
5. Install the fuel tank cap from the fuel ller neck.
6. Install the LH handle assembly . Using a 9/16 inch wrench, install the 2 (3/8
inch) bolts to secure the LH handle assembly to the motion control assembly .
7. Connect the seat pressure switch to the wire harness. Flip the seat down
and, using a 1/2 inch socket, install the 2 (5/16 inch) nuts and carriage bolts
to secure the rear of the seat to the chassis.
8. Connect the battery by installing the positive cable rst, then the negative
cable to the battery .
Right Hand Pod Replacement
Right Hand Pod Removal
1. Park the machine on a level surface and disengage the PT O. Stop the
engine, wait for all moving parts to stop and remove the key . Engage the
parking brake.
Chassis: Service and Repairs Page 6–22 2000 Series Z MASTER®Service Manual
3460-328 Rev A