ROPS Installation (continued)
2. Using a T40 torx driver , install the 2 (5/16 inch) screws to secure the lower
ROPS to the rear guard assembly .
3. Install the upper ROPS. Using a 3/4 inch wrench, install the 2 (1/2 inch) lower
shoulder bolts to secure the upper ROPS to the lower ROPS.
4. Raise the upper ROPS to the full-up position. Install the 2 ROPS fold pins
to secure the upper ROPS in place.
g422383
Figure 73
5. Connect the seat pressure switch to the wire harness and lower the seat.
6. Using a 1/2 inch socket, install the 2 (5/16 inch) nuts and carriage bolts to
secure the rear of the seat to the chassis.
7. Connect the battery by installing the positive cable rst, then the negative
cable to the battery .
Seat Replacement
Seat Removal
1. Park the machine on a level surface and disengage the PT O. Stop the
engine, wait for all moving parts to stop and remove the key . Engage the
parking brake.
2. Disconnect the battery by removing the negative cable rst, then the positive
cable from the battery .
3. Using a 1/2 inch socket, remove the 2 (5/16 inch) nuts and carriage bolts
securing the rear of the seat to the chassis.
Chassis: Service and Repairs Page 6–14 2000 Series Z MASTER®Service Manual
3460-328 Rev A
To Next Page
Loading...
