Hourmeter T esting (continued)
g336418
Figure 143
USB Power Port Replacement
USB Power Port Removal
1. Park the machine on a level surface and disengage the PT O. Stop the
engine, wait for all moving parts to stop and remove the key . Engage the
parking brake.
2. Disconnect the battery by removing the negative cable rst, then the positive
cable from the battery .
3. Remove the control panel. Refer to Control Panel Removal ( page 8– 9 ) .
4. Compress the 2 tabs on the side of the switch and remove the USB power
port.
USB Power Port Installation
1. Insert the USB power port into the control panel.
2. Install the control panel. Refer to Control Panel Installation ( page 8– 12 ) .
3. Connect the battery by installing the positive cable rst, then the negative
cable to the battery .
Left and Right Neutral Switch Replacement
Left and Right Neutral Switch Removal
1. Park the machine on a level surface and disengage the PT O. Stop the
engine, wait for all moving parts to stop and remove the key . Engage the
parking brake.
2. Disconnect the battery by removing the negative cable rst, then the positive
cable from the battery .
3. Remove the LH & RH pods. Refer to Left Hand Pod Removal ( page 6– 20 )
and Right Hand Pod Removal ( page 6– 22 ) .
4. Disconnect the wire harness from the LH & RH neutral safety switches.
Remove the neutral safety switches.
2000 Series Z MASTER®Service Manual Page 8–19 Electrical: Service and Repairs
3460-328 Rev A
To Next Page
Loading...
