Control Panel Removal (continued)
1 1. Remove the control panel.
g421536
Figure 135
Control Panel Installation
1. Install the control panel.
2. Hook the throttle and choke cables to the carburetor linkage.
3. Using a 1/4 inch socket, install the 2 (#8) bolts to secure the throttle and
choke cables to the engine.
4. Connect the wire harness to the USB power port.
g421559
Figure 136
5. Connect the wire harness to the hourmeter .
Electrical: Service and Repairs Page 8–12 2000 Series Z MASTER®Service Manual
3460-328 Rev A
To Next Page
Loading...
