Control Panel Installation (continued)
g421555
Figure 139
9. Using a T30 torx driver , install the 2 (1/4 inch) screws to secure the control
panel to the RH cover panel.
10. Connect the battery by installing the positive cable rst, then the negative
cable to the battery .
Main PT O Switch Replacement
Main PT O Switch Removal
1. Park the machine on a level surface and disengage the PT O. Stop the
engine, wait for all moving parts to stop and remove the key . Engage the
parking brake.
2. Disconnect the battery by removing the negative cable rst, then the positive
cable from the battery .
3. Remove the control panel. Refer to Control Panel Removal ( page 8– 9 ) .
4. Compress the 2 tabs on the side of the switch and remove the main PT O
switch.
Main PT O Switch Installation
1. Insert the main PT O switch into the control panel.
2. Install the control panel. Refer to Control Panel Installation ( page 8– 12 ) .
3. Connect the battery by installing the positive cable rst, then the negative
cable to the battery .
Electrical: Service and Repairs Page 8–14 2000 Series Z MASTER®Service Manual
3460-328 Rev A
To Next Page
Loading...
