Engine Installation (continued)
g420405
Figure 29
17. Using a 1/2 inch wrench, install the 2 (5/16 inch) nuts to secure the lower
portion of the muf er guard to the chassis.
18. Connect the battery by installing the positive cable rst, then the negative
cable to the battery .
19. Lower the machine.
Clutch Replacement
Clutch Removal
1. Park the machine on a level surface and disengage the PT O. Stop the
engine, wait for all moving parts to stop and remove the key . Engage the
parking brake.
2. Disconnect the battery by removing the negative cable rst, then the positive
cable from the battery .
3. Using a oor jack, raise the rear of the machine and secure with jack stands.
4. Remove the deck belt. Refer to Deck Belt Removal ( page 5– 7 ) .
5. Remove the hydrostatic drive belt. Refer to Hydrostatic Drive Belt Removal
( page 7– 10 ) .
6. Disconnect the wire harness from the clutch. Release the wire harness from
the mounting clip.
g420385
Figure 30
2000 Series Z MASTER®Service Manual Page 4–17
Engine: Service and Repairs
3460-328 Rev A
To Next Page
Loading...
