Hydrostatic Drive Belt Replacement
Hydrostatic Drive Belt Removal
1. Park the machine on a level surface and disengage the PT O. Stop the
engine, wait for all moving parts to stop and remove the key . Engage the
parking brake.
2. Disconnect the battery by removing the negative cable rst, then the positive
cable from the battery .
3. Using a oor jack, raise the rear of the machine and secure it with jack stands.
4. Remove the deck belt. Refer to Deck Belt Removal ( page 5– 7 ) .
5. Using a 1/2 inch breaker bar , rotate clockwise to release tension on the
spring.
g420403
Figure 1 10
6. Remove the belt from the clutch. Remove the hydrostatic belt.
Drive: Service and Repairs Page 7–10 2000 Series Z MASTER®Service Manual
3460-328 Rev A
To Next Page
Loading...
