Hydrostatic Drive Belt Removal (continued)
g420402
Figure 1 1 1
Hydrostatic Drive Belt Installation
1. Install the hydrostatic belt to the clutch.
2. Using a 1/2 inch breaker bar , rotate counter-clockwise to increase tension
on the spring.
g420403
Figure 1 12
3. Install the deck belt. Refer to Deck Belt Installation ( page 5– 9 ) .
4. Lower the machine.
2000 Series Z MASTER®Service Manual Page 7–1 1 Drive: Service and Repairs
3460-328 Rev A
To Next Page
Loading...
