Starter Solenoid Replacement
Starter Solenoid Removal
1. Park the machine on a level surface and disengage the PT O. Stop the
engine, wait for all moving parts to stop and remove the key . Engage the
parking brake.
2. Disconnect the battery by removing the negative cable rst, then the positive
cable from the battery .
3. Using a 1/2 inch socket, remove the 2 (5/16 inch) jam nuts securing the
battery positive and the battery positive starter cable to the starter solenoid.
g420412
Figure 123
4. Using a 3/8 inch socket, remove the 2 (#10) nuts to disconnect the 2 wire
harness connectors from the starter solenoid.
g420414
Figure 124
5. Using a T30 torx driver , remove the 2 (1/4 inch) bolts securing the starter
solenoid to the chassis. Remove the starter solenoid.
Electrical: Service and Repairs Page 8–6 2000 Series Z MASTER®Service Manual
3460-328 Rev A
To Next Page
Loading...
