Left and Right Neutral Switch T esting
g427668
Figure 146
The neutral switch is a single pole plunger type switch (normally open) with
two terminals. When the plunger is depressed, the circuit closes and there is
continuity between the terminals. This allows battery voltage to ow to the Smart
Hour Meter for the safety interlock system.
• Motion control levers in neutral position (OUT), the switch will have continuity
(closed).
• Motion control levers in the operating position (IN), the switch will NOT have
continuity (open).
Parking Brake Switch Replacement
Parking Brake Switch Removal
1. Park the machine on a level surface and disengage the PT O. Stop the
engine, wait for all moving parts to stop and remove the key . Engage the
parking brake.
2. Disconnect the battery by removing the negative cable rst, then the positive
cable from the battery .
3. Using a 1/2 inch socket, remove the 2 (5/16 inch) carriage bolts and nuts
securing the rear of the seat to the chassis.
4. Lift the seat forward and disconnect the seat pressure switch from the wire
harness.
5. Disconnect the wire harness from the parking brake switch. Remove the
parking brake switch.
2000 Series Z MASTER®Service Manual Page 8–21 Electrical: Service and Repairs
3460-328 Rev A
To Next Page
Loading...
