Parking Brake Switch Removal (continued)
g421531
Figure 147
Parking Brake Switch Installation
1. Install the parking brake switch. Connect the wire harness to the parking
brake switch.
g421531
Figure 148
2. Connect the wire harness to the seat pressure switch and lower the seat
into place.
3. Using a 1/2 inch socket, install the 2 (5/16 inch) carriage bolts and nuts to
secure the rear of the seat to the chassis.
Electrical: Service and Repairs Page 8–22 2000 Series Z MASTER®Service Manual
3460-328 Rev A
To Next Page
Loading...
