Toro Z MASTER 2000 Series - Engine Replacement

Engine Replacement
Engine Removal
1. Park the machine on a level surface and disengage the PT O. Stop the
engine, wait for all moving parts to stop and remove the key . Engage the
parking brake.
2. Disconnect the battery by removing the negative cable rst, then the positive
cable from the battery .
3. Using a 1/2 inch wrench, remove the 2 (5/16 inch) nuts securing the lower
portion of the muf er guard to the chassis.
4. Using a T40 torx driver and a 1/2 inch wrench, remove the 2 (5/16 inch)
screws/nuts securing the muf er guard to the rear guard assembly . Remove
the muf er guard.
g420405
Figure 6
5. Using a T40 torx driver and a 1/2 inch wrench, remove the 4 (5/16 inch)
screws/nuts securing the left and right sides of the rear guard assembly .
g420406
Figure 7
Engine: Service and Repairs
Page 4–6 2000 Series Z MASTER®Service Manual
3460-328 Rev A