Engine Installation (continued)
2. Using a 9/16 inch socket, install the 4 (3/8 inch) bolts to secure the engine to
the chassis. T orque to 41 ± 4 N•m (30 ± 3 ft-lb).
g420390
Figure 17
For securing, refer to the torque sequence below .
g431 179
Figure 18
3. Install the clutch. Refer to Clutch Installation ( page 4– 18 ) .
4. Install the hydrostatic drive belt. Refer to Hydrostatic Drive Belt Installation
( page 7– 1 1 ) .
5. Install the deck belt. Refer to Deck Belt Installation ( page 5– 9 ) .
6. Using a 1/2 inch socket, install the (5/16 inch) bolt securing the engine ground
to the engine crankcase. For Briggs engines, using a 7/16 inch socket,
install the 1/4 inch bolt securing the engine ground to the engine crankcase.
2000 Series Z MASTER®Service Manual Page 4–1 1
Engine: Service and Repairs
3460-328 Rev A
To Next Page
Loading...
