Clutch Installation (continued)
2. Using a 5/8 inch socket, install the (7/16 inch) clutch bolt to secure the clutch
to the engine. T orque to 75 ± 8 N•m (55 ± 6 ft-lb).
g420384
Figure 33
3. Secure the wire harness into the mounting clip. Connect the wire harness
to the clutch.
4. Install the hydrostatic drive belt. Refer to Hydrostatic Drive Belt Installation
( page 7– 1 1 ) .
5. Install the deck belt. Refer to Deck Belt Installation ( page 5– 9 ) .
6. Lower the machine.
7. Connect the battery by installing the positive cable rst, then the negative
cable to the battery .
2000 Series Z MASTER®Service Manual Page 4–19
Engine: Service and Repairs
3460-328 Rev A
To Next Page
Loading...
