Parking Brake Assembly Installation (continued)
5. Install the 2 cotter pins to secure the LH and RH lower park brake linkages
to the transaxles.
g421548
Figure 97
6. Install the cotter pin and clevis pin to secure the parking brake upper linkage
to the brake shaft.
7. Install the handle. Using a 9/16 inch wrench, install the (3/8 inch) bolt and nut
to secure the parking brake handle to the chassis.
g421529
Figure 98
8. Connect the parking brake linkage from the parking brake handle. Install the
pin to secure the parking brake linkage to the handle.
9. Using a T40 torx driver , install the 2 (5/16 inch) bolts to secure the LH
mounting bracket to the chassis.
10. Using a T40 torx driver , install the 2 (5/16 inch) bolts to secure the LH pod
tube to the chassis.
1 1. Install the LH pod. Refer to Left Hand Pod Installation ( page 6– 21 )
12. Connect the seat pressure switch from the wire harness and lower the seat
back.
13. Using a 1/2 inch socket, install the 2 (5/16 inch) nuts and carriage bolts to
secure the rear of the seat to the chassis.
14. Lower the machine.
15. Connect the battery by installing the positive cable rst, then the negative
cable to the battery .
Chassis: Service and Repairs Page 6–28 2000 Series Z MASTER®Service Manual
3460-328 Rev A
To Next Page
Loading...
