MYRIDE ® Removal (continued)
g424552
Figure 79
7. Support the front of the MYRIDE® subframe. Using a 3/4 inch wrench,
remove the (1/2 inch) lock nut and carriage bolt from the front shock mount.
Displace the shock and re-install the carriage bolt and lock nut to use as a
lift point.
g424553
Figure 80
8. Lower the ROPS to the full-down position.
9. Support the rear of the MYRIDE® and remove the rear shocks from the
support tabs on the lower half of the ROPS.
10. Using a 1/2 inch socket, remove the 4 (5/16 inch) lock nuts and carriage bolts
securing the MYRIDE® trailing arm to the chassis.
g429402
Figure 81
Chassis: Service and Repairs Page 6–18 2000 Series Z MASTER®Service Manual
3460-328 Rev A
To Next Page
Loading...
