Toro Z MASTER 2000 Series - Page 83

MYRIDE ® Removal (continued)
1 1. Using an appropriate lifting device, fully raise the MYRIDE® assembly out
of the machine.
MYRIDE ® Installation
1. Using an appropriate lifting device, install the MYRIDE® assembly into the
machine.
2. Raise the ROPS.
3. Using a 1/2 inch socket, install the 4 (5/16 inch) lock nuts and carriage bolts
to secure the MYRIDE® trailing arm to the chassis. T orque to 27 ± 3 N•m
(240 ± 25 in-lb).
g429402
Figure 82
4. While supporting the rear of the MYRIDE® assembly , install the rear shocks
to the support tabs on the lower half of the ROPS.
5. Using a 3/4 inch socket, install the 2 (1/2 inch) lock nuts to secure the lower
mount of the rear shocks to the ROPS. T orque to 122 ± 12 N•m (90 ± 9 ft-lb).
6. Using a 3/4 inch wrench, install and tighten the (1/2 inch) lock nut and carriage
bolt to the front shock mount while supporting the front MYRIDE® subframe.
Note: Do not over-tighten the carriage bolt. The shock must pivot freely .
7. With assistance, install the seat and pan assembly .
8. Move the seat as needed and, using a 1/2 inch socket, install the 4 (5/16 inch)
lock nuts and carriage bolts to secure the seat pan to the MYRIDE® platform.
Note: Only 2 of the 4 lock nuts are shown in the image below .
2000 Series Z MASTER®Service Manual Page 6–19 Chassis: Service and Repairs
3460-328 Rev A