Engine Installation (continued)
g420419
Figure 25
14. Install the rear guard assembly . Using a T40 torx driver and a 1/2 inch
wrench, install the 2 (5/16 inch) screws to secure the upper portion of the
rear guard assembly .
g420408
Figure 26
15. Using a T40 torx driver and a 1/2 inch wrench, install the 4 (5/16 inch)
screws/nuts to secure the left and right sides of the rear guard assembly to
the chassis.
2000 Series Z MASTER®Service Manual Page 4–15
Engine: Service and Repairs
3460-328 Rev A
To Next Page
Loading...
