Trunks
300 Trunk Assignment
Strata CTX Programming - Part 2: CTX WinAdmin Programming 11/03 6-11
Trunks
310 DIT Assignment
Prerequisite Program: 300 page 6-6
This program assigns DIT Number Analysis Table for DIT trunks. DIT trunks are ground and loop start
trunks.
1. Complete the “Trunk Timer/DIT
Record Sheet” on page D-27.
2. From the Program Menu, click
Trunk > Assignment, then click the
DIT tab. The DIT Assignments
screen displays (shown right).
3. Enter Trunk equipment number
field. Enter Program 310 data.
•List – to view a summary list of
programmed Trunks timers.
• Copy – to copy to trunk timer
ports.
4. Click Submit.
FIELD DESCRIPTION
Line No. Enter the trunk equipment number. Equipment numbers are required when
assigning a new trunk to the system. It can also be used to display the equipment
location of existing trunks.
Example: If a line should be assigned to an RCOU in cabinet shelf 5, slot 2, circuit 3,
enter 050203.
Possible values: xx = cabinet 01~07; yy =slot 01~10; zz = circuit 01~08 or Channel
01~24 (CTX670).
xx = cabinet 01; yy =slot 01~08; zz = circuit 01~24 or Channel
(CTX100)
(default = no value).
Cabinet numbers:
• CTX100 – Select 01 for Base and Expansion cabinet.
• CTX670 – Select 01 for Base and 02~07 respectively for each Expansion
cabinet.
Slot numbers:
• CTX100 – Select 01~04 for Base slots and 05~08 for Expansion slots.
• CTX670 – Select 01~08 for Base slots and 01~10 for Expansion slots.
To Next Page
Loading...
