Trunks
Service
Strata CTX Programming - Part 2: CTX WinAdmin Programming 11/03 6-19
Trunks
Service
Program Number(s): 311 and 319
These commands assign Assigns Direct Inward System Access (DISA) properties.
1. From the Program Menu, click
Trunk > Service. The Trunk
Services screen displays (shown
right).
2. Enter Program 311 data.
3. Enter Program 319 data.
4. Click Submit.
311 DISA Security Code
Prerequisite Program: None
Assigns DISA parameters.
319 Intercept Treatment
Prerequisite Program: None
This command assigns Intercept positions for Strata CTX Day/Night schedules. Intercept positions are
used when the destination of a trunk line call is not determined with DID or DIT.
FIELD DESCRIPTION
01 DISA Enabled Enable DISA security code.
Possible values: Enable or Disable (default)
02 DISA Code Enter DISA security code.
Possible values: Up to 15 digits (default = no value)
03 Response Timer Enter the time, in seconds, for Strata CTX to respond to a call.
Possible values: 0~30 (default = 5)
04 Idle Timer Enter the time in seconds to wait for idle DTMF.
Possible values: 0~60 (default = 10)
05 Tie Line Access Enable this feature to allow DISA callers to access Tie lines when they call into the
system. (This feature is available with CTX R2.2 or higher and CTX WinAdmin
R2.2G.0 and higher.)
Possible values: Enable or Disable (default)
FIELD DESCRIPTION
Tenant Number Select the Tenant number for which the Intercept Destinations should be
assigned.
Possible values: 1~8.
To Next Page
Loading...
