Toshiba CTX100-S - CTX Processor NIC Interface TCP;IP Auto-Programming

Strata CTX Programming Guidelines
Step 1: Use Default Auto-programming to Start Up
1-8 Strata CTX Programming - Part 1: Getting Started 11/03
CTX Processor NIC Interface TCP/IP Auto-programming
The following are the initial values of the LAN data that is automatically created for the system.
• Network TCP/IP. See “916 IP Configuration” on page 10-14.
• IP address – 192.168.254.253
• Sub network master – 255.255.255.0
• Default gateway – 0.0.0.0
• IP routing table – Not used.
• SNMP Agent settings
• Community name – communityName
• IP address – 0.0.0.0 (not restricted by the IP address of the access source)
• Privileges –
WRITE
• community-id – 1
• User level – Super user
• Trap destination
• Community name – Nothing
• IP address – Nothing
• Modem PPP Server settings
• IP Address – 192.168.255.254 (Strata CTX modem fixed IP address for Dial-up connections).
Public Numbering Plan Analyzed Digit Numbers (Program 117)
E911 Emergency Call to Outgoing Line Group (Program 550)
E911 Emergency Call Destination (Program 400)
Public Numbering Plan
Analyzed Number
Public Numbering Plan
Analyzed Digit Number
1NXX 11
N11 3
NXX 7
N = 2~9 and X = 0~9
Emergency Call Group
Number
OLG1
11
System Mode
Emergency Call Called Number
Index
Emergency Call Called Number
DAY1 1 200 or 2000 (the first PDN)
DAY2 1 200 or 2000 (the first PDN)
NIGHT 1 200 or 2000 (the first PDN)
The emergency call destination is set for the first PDN as 200 or 2000 in the all operation mode (DAY1,
Day2, NIGHT).