Toshiba CTX100-S - MAC Address (System Serial Number)

Telephone Button Programming
900 Series Programs
Strata CTX Programming - Part 3: Telephone Button Programming 11/03 13-105
Telephone Button
Programming
MAC Address (System Serial Number)
This program enables you to display your CTX 670 System Serial Number.
Program Number(s): 909
Prerequisite Program:
None
Reference: None
Access Sequence: Login to programming mode from your telephone button pad:
+ROG✱✱✱✱✱.
At the PASSWORD= prompt, Enter your password and press+ROG.
At the PROG= prompt enter  and press +ROG.
1. Press )% to view parameter. The MAC Address is view only and cannot be changed.
2. Press
+ROG (twice) to exit to the 352*= prompt.
3. Enter another program number to continue programming or press
+ROG again to exit programming
mode.
Data Backup
This program enables you to Back up system data to a SmartMedia card.
Program Number(s): 910
Prerequisite Program:
“Format/Unmount SmartMedia” on page 13-103
Reference: None
Access Sequence: Login to programming mode from your telephone button pad:
+ROG✱✱✱✱✱.
At the PASSWORD= prompt, Enter your password and press+ROG.
At the PROG= prompt enter  and press +ROG.
FB Name FB Summary Value LCD Prompt
MAC Address
01 Display System Serial Number. 12 digits MAC Address
FB Name FB Summary Value LCD Prompt
Backup Function 01 Start and Stop system backup.
Note Restore function is not operational
and should never be executed.
Use System Initialize (Program
900) Level 1 to restore system
backup.
1:Backup
2:Restore (Do not
use. See Note on
left).
3:Cancel
1:BACKUP
2:RESTORE
3:CANCEL
Numbers 02 The number of data blocks. This number
varies depending on the amount of
programming the system contains.
Variable ALL NO=
Current Number
03 This number increments as the backup
progresses. When the backup is complete
this number should match the total number
of data blocks displayed in Numbers
()%).
Variable CUR NO=